Mc-leod How to Bleed McLeod Hydraulics Manuel d'utilisateur télécharger pdf

How to properly bleed your new Hydraulic Bearing

Always have the AN -4 line with the bleeder valve at the top when the bearing is

properly installed. It is OK to swap the lines on the swivel fittings if necessary.

Remember the line with the bleeder valve must be at the top position!

Fill the master cylinder with DOT 3 or DOT4 brake fluid. DO NOT USE SILICONE BASED

FLUID or DOT 5 FLUID!! Use of silicone or synthetic fluid will damage the o-rings resulting

in leaks and or damage to the assembly.

After the master cylinder is filled, bleed the bearing assembly. Example: Pump the pedal 3

to 4 times, with the bleeder valve open and the end of the opening submerged in a cup

partially filled with brake fluid. This will release fluid and air trapped in the system.

Continue the bleeding process until all of the air is removed from the system. Always keep

fluid in the master cylinder while performing the bleeding process. Now reach into the cup

and tighten the bleeder fitting while fitting is submerged under fluid. Set the cup aside and

then be sure to tighten the bleeder valve.

Once the bleeding is complete refill the master cylinder, just don’t fill it all the way to the top.

The fluid level should be ½” to ¾” from the top. This will allow room for the brake fluid in the

reservoir when the bearing self adjusts. Unlike brakes, the fluid level will rise

in the master

cylinder, as the clutch wears, not lower.

Page 1

How to properly bleed your new Hydraulic Bearing Always have the AN -4 line with the bleeder valve at the top when the bearing is properly installe

Pas de commentaire

Mc-leod How to Bleed McLeod Hydraulics Manuel d'utilisateur